Clicky

BIQU MKS-BASE V1.5 Plate Controller Board for 3D Printer Ramps 1.4 - Read Reviews and Compare

By BIQU
7

rating

BIQU MKS BASE Plate Controller Printer
Category: Industrial & Scientific
7.0

Overall Score

This is the overall score of the product based on buyer reviews, product popularity and the brand reputation.

7.8

Review Score

Product score based on 37 buyer reviews.

5.2

Popularity

Score based on the current sales volume of this product.

8.0

Brand Score

Score based on the overall range of products sold by BIQU.

BIQU Brand Analysis

BIQU has 76 products available for sale in the category of Industrial & Scientific.

BIQU is rated 8 out of 10 based on 1,809 reviews.

BIQU Quality Chart


Specifications:
a Set of all the functions on a single board to Resolve the complicated interfaces Ramps1.4 combination, problem-prone Error
Using high-quality MOSFET tube Heating Simpler
Control panel and can be Attached directly Ramps1.4,2004LCD 12864LCD Controller panel
Net Weight:80g
Dimension:110*90mm


Notice:
Before powering up again affirm whether the positive and negative reversed, even if the consumer is supposed to reverse electricity and burnoff, and we don't guarantee these problems
Do not plug in case of electricity motor drive readily lead to burn; don't adjust the current from the engine is running. The Right strategy is to first disconnect the power, unplug the engine, and then re-power, correct potentiometer, measure the voltage on the potentiometer until the measured voltage will be the same as expected
MKS-BASE is to create customer foundation for R & D employees Ramps1.4, Megatronics V2.0 along with other open source motherboard issues especially developed to maximize the launch of a product, particularly suitable for mass production 3D printer manufacturers use as the main control board
Give Whole attention to the firmness, heat dissipation, ease of use issues through constant printing reliability testing
If special needs can contact the owner with details
Supporting line may refer to: 2PIN, 3PIN, 4PIN
Might Be directly connected 2004LCD or 12864LCD (eliminate the L-shaped adapter plate), due to the open design layout 12864LCD 2004LCD and only standardized EXP1 and EXP2 the PIN port about the horns insertion direction and There's No specific standard, so a few non Makerbase production and 2004LCD 12864LCD Might Be conflicting information line card interface management, in turn, need to plug to utilize


Bundle included:
1* MKS-Base V1.4 3D Printer Controller Board
1* USB Cable

Note: The socket shade is ramdon, please double confirm that you do not mind before placing order.

See more

This product is ranked:

#1 in 3d printer board

#1 in 3d printer controller

#1 in 3d printer control board

#1 in 3d printer ramps

#1 in 3d printer motherboard

#1 in 3d printer controller board